1
Morrison Bros. Co. - Dubuque, IA - 800-553-4840
246A--0109 PP
!
!
Maintenance Instructions on Back
!
The 246 Series valves are designed to provide single-direction fl ow in a horizontal pipeline and/or isolate
product in a multi-product handling system.
Failure to follow any or all of the warnings and instructions in this document could result in a hazardous
liquid spill, which could result in property damage, environmental contamination, fi re, explosion, serious
injury, or death.
Installation
Warnings
•
Fire Hazard
– Death or serious injury could result from spilled liquids.
• Install in accordance with all applicable local, state, and federal laws.
• For your safety, it is important to follow local, state, federal and/or OSHA rules that apply to working inside,
above, or around the storage tank and piping area. Use all personal protective equipment required for working
in the specifi c environment.
• Piping could be under pressure. Liquid and vapors may be expelled from the piping, valves or fi ttings while
performing installation. Liquids and vapors could catch fi re or cause an explosion.
Avoid
sparks, open fl ame, or
hot tools when working on valves.
Steps
1. Inspect valve for shipping damage. Do not use if valve is damaged. Call Morrison Bros. Co. for assistance.
2. Inspect valve openings for foreign matter such as packaging material. Remove any that is found.
3. Prior to mounting the valve in the piping, verify the intended direction of liquid fl ow. The 246 Series valves
must be mounted in the horizontal plane with the valve cap pointing straight up.
4. The valve is marked with a fl ow direction arrow. Make certain to install the valve such that the fl ow of liquid
through the valve corresponds with the fl ow arrow.
5. If the valve has threaded connections, apply a non-hardening, fuel resistant thread sealant to the male threads
of the pipe. When threading the valve onto the piping, and the piping into the valve, make certain to wrench on
the valve hex closest to the end you are threading.
6. If valve has fl anged connections, install a compatible gasket between the valve fl anges and the pipe fl anges.
Install the appropriate mounting bolts and nuts. Gradually tighten bolts in a crisscross pattern.
7. You may now introduce liquid to the valve. Inspect the valve and piping for leaks. Repair as is necessary.
Failure to follow any or all of the warnings and instructions in this document could result in a hazardous
liquid spill, which could result in property damage, environmental contamination, fi re, explosion, serious
injury or death.
Fig. 246 Swing Check Valve
Installation & Maintenance Instructions
