The steam wand can be used to froth milk and make hot beverages like
drinking hot
chocolate,
water
or tea.
Method:
1.
Remove the removable water tank and fill it with water. The water level should not exceed the
“MAX” mark in the tank.
Then insert the tank into the appliance properly.
2.
C
onnect the appliance to power supply.
3. Press down the ON/OFF button “ ” to turn
on the unit
. Th
e power indicator (red)
illuminates.
4. Press
once
the pump control button
'' ''
. Make sure the coffee/steam button '' ” is
not pressed. The pump will pump water
. Wh
en water
is
flowing out, close the pump immediately.
5. Press down the coffee/steam button
'' ” to the lower position and wait for a moment, the
appliance begins to heat until the (yellow) lamp illuminates,
which
means th
at
heating is finished.
6. Dip the steam wand into the liquid to be heated. If you want to froth milk, dip the steam wand about
2
c
m.
into milk. Turn the steam knob anti-clockwise slowly to start making steam.
7.
W
hen desired result is
reached
, you can turn the steam knob to “O” position and press the coffee/
steam button “ ” to the higher position.
8.
FROTHING MILK
/
PRODUCING STEAM TO HEAT LIQUIDS
9. Press and release the ON/OFF button
“ ” to cut off the power source.
Note
:
If the steam outlet is blocked, p
lease follow the
procedure below
:
(1)
turn the steam knob to “O”
position and
let
coffee maker cool down for about half an hour
, (2)
p
oke the steam outlet for several times with
a needle
of
about 1mm diameter
, (3)
press
once
the coffee/steam button “
” and turn on the steam knob to
check if the appliance can produce steam normally when the steam indicator (yellow) illuminates. Please
contact the service department if the appliance
still
cannot produce steam after above.
Note
: after steaming,
it is
recommend
ed
to
allow
coffee
maker to cool down at least for 5 min
.
before
making coffee again. Otherwise burnt odor may occur in your Espresso. If you want to make coffee
immediately, follow the next steps:
(1)
press and release the steam button “ ”
once, then
dip the steam wand
into a cup;
(2)
press the pump control button “ ”
once
and turn on the steam control knob
(
there will be
water flow out from steam wand
). A
fter the ready indicator extinguish, press and release the pump control
button “ ”, then turn the steam control knob to “O” position. When the ready indicator illuminate
s
, you can
start to brew coffee again.
After producing frothing milk (every time), p
lease follow the
procedure
below to
protect
the steam
outlet
from
being blocked
: put an empty jug under the steam band, then turn on the steam knob
and
press
once
the
pump control button “ ”
. T
he pump will pump
water
.
A
fter water
is
flowing
out for
30 sec
.
, press
again the
pump control button “ ”
.F
inally clean the steam
outlet with wet sponge
. Be
cautious not to get burned
!
8