9
10. HUMIDIFICATION
1. The unit will stop automatically after four hours operating in this mode. Please put
some water (Approx 0.8L) into the filler and turn it on again.
2. The unit will stop humidifying if ambient humidity is equal to the pre-set humidity.
Otherwise it will work as the humidifying procedure1.
3. The fan motor and water motor will work, but compressor doesn’t work.
11. PURIFICATION
Ionizer function will
auto start when unit work. When select this function,
the purification indicator light will be on and only the fan motor works.
When the fan motor’s life time is larger than 2000hrs
，
the indicator light will flash
，
and LCD display E8, it means the filter should be changed
；
Change the active
carbon filter and press SPEED button for 3 seconds and alarm reset.
12. SLEEP CONTROL
FUNCTION
1. While in cooling mode, press
the SLEEP key to set the temperature. It
increases1
℃
after an hour and at most increases 2
℃
after 2 hours.
2. Press the SLEEP key again can cancel the setting.
13.
SWING
Press
this key and the outlet will oscillate and it will stop when this key
is pressed again. The outlet will close up automatically when the unit stops
working.
14.
HEATING FUNCTION WILL START
PTC
(1) Heating function , temperature setting range
is 15
～
25
℃
(2) Temperature can be set, when the environment temperature is lower than
setting temperature, it will start heating
(3) PTC will work only when the environment temperature<25
℃
15. ALARM
When the water tank is full,"E4" will be displayed on the display panel. To resume
operation, please remove the rubber cap of the drain hose to drain out the water
firstly. The E4 warning will disappear after draining, and then you can restart the
unit by pressing the POWER key.
16. CHILD
LOCK
Press“+”and“-”at the same time for three seconds, the unit
will enter child lock function, and it will be unlocked by pressing the two buttons
again.