5
Vacuum cleaning
1
Turn the product on by pressing the on/off
button
(2)
.
During use, when the battery is fully charged, all
five charging/power indicator lights
(8)
and the
floor brush power indicator light
(11)
will
illuminate.
The number of illuminated charging/power
indicator lights reduces as the stored battery
power is used. This is then replaced by a single
red light shortly before the product auto-stops.
The battery must then be recharged.
If the motorised floor brush
(12)
is stalled,
eg. by a foreign object or if used on very deep
pile carpet, the floor brush power indicator light
(11)
will extinguish. Switch off, remove the
cause of the stall, and leave for a few minutes
to allow the floor nozzle protection to self reset.
To clean the motorised floor brush, press the
floor brush release button
(10)
and pull the
motorised floor brush away.
5
Remove the brush bar cover and lift the brush bar
out. Pull away any hairs or fibres from the brush
bar. If they are tightly wound around the brush,
carefully snip the fibres with scissors, being careful
not to damage the rotating brush bar, pull away
from the rotating brush bar and dispose. Replace
the brush bar and cover in their original position.
On certain models, two power settings are
provided. Press the on/off button
(2)
once to
switch the product on at high power, press the
button a second time to switch to low power,
then a third press switches the product off again.
Using the product on low power will be sufficient
for light cleaning and will extend the running time
until the product needs to be recharged.
2
4
Turn the motorised floor brush
(12)
over to
inspect the brush bar.
Using a coin, turn the locking button on the
brush bar cover anti-clockwise from the
position to the
position.
3
VC732008MUK Rev2.qxp_Instruction Book 06/10/2015 09:21 Page 5
