44
BEFORE FIRST USE
Before using the toaster for the
first time, operate the toaster
without bread.
Note: the bread carriage levers
¤
will not stay down unless the
toaster is plugged in and the
wall switch is on. Ventilate the
room during this period.
As with all new electric heating
elements, your toaster emits a
‘new’ smell when it is first
switched on. This is quite normal
and not a cause for concern.
OPERATING THE
APPLIANCE
Toasting
1
Select the desired level of
browning on the browning
control
·
marked 1 to 9. The
setting required will vary
according to the moisture
content and thickness of the
bread.
2
After selecting the desired level,
place your bread in the slots
⁄
and depress the bread carriage
lever downwards until it locks.
3
After the set time has been
reached, the bread will pop up
automatically - ready for removal
from the slots. The bread
carriage lever will have returned
to it’s upper position and the
heating element will have
switched off.
•
If the bread in your toaster
becomes jammed, disconnect
your toaster at the socket, allow
it to cool, then remove the
bread.
•
When not in use, remove the
plug from the mains socket.
•
Allow the toaster to cool fully
before putting away.
WARNING: Do not wrap the
cable around the main body
of the appliance during or
after use.
Using the frozen
button
To toast frozen bread, do not
adjust the browning control from
your normal preferred setting,
place the bread normally in the
bread slots, then depress the
bread carriage lever and press
the relevant frozen button
fl
.
The button will illuminate and
the toaster will operate for a
longer period.
Using the re-heat
button
If your toast has popped up and
gone cold, the toaster offers a
re-heat facility. To use, depress
the bread carriage lever and
press the reheat button
fi
. The
button will illuminate and the
toaster will operate for a short
period,
re-heating the bread.
Using the cancel
button
(44234, 44235,
44236, & 44237)
If you wish to interrupt the
toasting process, press the
cancel button
‹
.
Using the pause
and check /
cancel button
(44238, 44239, & 44240)
If you wish to check the process
of the toasting cycle, press the
Pause and check / cancel
button
‹
. On pressing the
button, the bread carriage will
pop up automatically for you to
check. This action will pause the
heating elements, during this
period, the function button lights
will flash. If you have achieved
the desired level of browning,
remove the toast from the
toaster. If longer toasting is
required, depress the bread
carriage lever within 5 seconds
to resume the toasting cycle at
the same stage it was at when it
was paused.
UUKK HHeellpplliinnee 00884444 887711 00995577
RReeppllaacceem
meenntt PPaarrttss 00884444 887733 00772233
IIrreellaanndd HHeellpplliinnee 11880000 440099 111199
44234-44240 Rev1 16/4/08 10:28 Page 6
