Using
1
Wherever possible fill through the spout,
as this helps to free the filter from
limescale build-up.
The kettle can also be filled through the
lid. Use the lid release button
¤
to
open.
• IMPORTANT : When filling from a tap,
care must be taken to avoid striking the
glass body on the tap.
• Always ensure that the level of water in
the kettle is filled to at least the minimum
level shown on the water level indicator.
• Boil only as much water as you need as
this saves electricity.
2
Place the kettle on the base unit,
ensuring the kettle locates on to the 360˚
connector.
• The 360˚ connector allows the kettle to
be located at any position. - ideal for left
and right handed users and for
convenient positioning on worktop.
3
Plug in and switch on at the wall socket.
4
Switch the kettle on. The ‘power on’
neon and the kettle glass body, will light
up.
5
When the water boils the kettle will
switch off automatically.
• If you are using the kettle for the first
time, pour away the boiled water and
refill.
6
Lift the kettle from the base unit by the
handle ensuring you hold the kettle level.
• To re-boil, switch to ON again. If the
kettle has just switched off wait a minute
or so before switching it back on again.
• If you do not put in enough water, or
switch on the kettle when it is empty, the
safety cut-out will switch off the power
automatically. If this happens, refill and
wait a few minutes for the element to
cool, then use as normal.
Filter removal
1
Open the lid using the release button
¤
.
2
Lift the filter upwards to remove.
3
To refit the filter, slide it into the side
guides of the filter holder until it clicks
into place. Ensure the filter is correctly
located.
WARNING: Unless the filter is fitted
correctly, the kettle lid may not close
and the kettle may not switch off after
boiling.
4
43121 rev 1 11/4/05 10:34 AM Page 4
