USING YOUR STRAIGHTENER:
1.
After washing your hair, it’s really important to prepare it for styling. If you use lots of heated
styling tools on your hair use a heat protection spray before you begin styling. Always dry the
excess water from your hair using a towel, and then use a wide toothcomb to detangle and
smooth your hair.
2.
Use your hairdryer until your hair is completely dry.
3.
Divide your hair into sections, and comb each section through.
4.
Use sectioning clips to clip hair out of the way so you can straighten hair thoroughly.
5.
Plug in your hair straightener base at the mains. There is space for cable storage in the
straightener base, so you may need to unwind the cable to reach your mains socket.
6.
Press and hold the On/Off button and the digital display will illuminate to show the product is
switched on and is heating up. The temperature will be displayed on the screen (the unit will
switch on at 120 degrees). To alter the temperature use the +/- buttons until you find the best
setting for your hair type. The minimum setting is 120 degrees which is ideal for fine hair, the
maximum temperature is 200 degrees which is better for thicker or coarser hair.
You should experiment to find the lowest setting your hair needs to help minimise damage.
7.
When ready for use, the word ‘ready’ will appear on the screen and begin to flash. Lift your
straightener from the base (the word ready will disappear to indicate the straightener has
been removed from the base). Clamp a section of the hair between the straightening plates,
as close to the roots as possible. Gently slide the straightener down your hair shaft to the
ends. For more difficult sections of hair, you may need to do this again. Repeat on all sections
of the hair.
Summary of Contents for IB22071
Page 2: ......