66
U
UK
K H
He
ellp
plliin
ne
e 00887700 006600 22660044
R
Re
ep
plla
ac
ce
em
me
en
ntt P
Pa
arrttss 00887700 116677 66663355
IIrre
ella
an
nd
d H
He
ellp
plliin
ne
e 11880000 440099111199
6
FILTERS
Replacing the HEPA
exhaust filter
E
The HEPA exhaust filter should
be replaced every 6 months.
•
Replacement filters can be
purchased from our replacement
parts helpline.
1
Remove the front grille
E
to
access the HEPA filter.
Safety cut-out
If the cleaner overheats a motor
protection thermostat will
automatically switch the motor
off. If this happens, switch the
cleaner off, unplug from the
power supply and leave the
cleaner to cool for at least 60
minutes. Check the airways for
blockages, replace the dust bag,
clean the pre-motor filter and if
necessary change the HEPA
filter.
Changing the belt
If the brush bar stops rotating it
is likely that the drive belt has
snapped (usually because the
brush has been stalled). A spare
belt is supplied. Replacement
belts can also be obtained from
Morphy Richards.
Removing the floor
nozzle cover
FG
1
Disconnect the cleaner from the
mains supply.
2
Press the handle release pedal
and place the cleaner face
down, in the flat position on a
soft surface (eg carpet).
3
Use a cross-head screwdriver to
remove the four screws
indicated
F
.
4
Turn the cleaner over.
5
While pressing the handle
release pedal lift the rear of the
top cover, unhook from the front
then completely remove the
cover
G
.
Replacing the belt
HI
6
Lift off the belt cover
Î
.
7
Gently pull the right hand side
(belt side) of the floor nozzle
outwards and at the same time
lift the brush bar
Ï
out of its
location
H
.
8
If the belt has broken, ensure all
pieces are removed. Clean the
motor shaft
Ì
.
9
Check the brush bar end caps.
Ó
10
Fit the left hand end cap into the
floor nozzle.
11
Fit the right hand end cap onto
the brush bar.
12
Place one end of the new belt
over the motor shaft
Ì
and the
other around the pulley end of
the brush
Ï
.
13
Locate the left hand side of the
brush bar first, then while pulling
the right hand side of the nozzle
gently outwards and stretching
the belt, lower the right hand
side of the brush into its
location.
14
Rotate the brush by hand to
ensure it is correctly and
securely located.
15
IMPORTANT: Re-fit the belt
cover.
16
Replace the top cover, hooking it
in at the front first and by
pressing the handle release
pedal to allow the rear to
correctly locate
J
.
17
Turn the cleaner face down and
re-fit and tighten the four fixing
screws, do not overtighten.
18
Return the cleaner to its correct
working position before re-
testing.
F
G
E
Î
Ï
H
Ì
Ó
I
J
73342 rev1 13/3/07 15:02 Page 6
