5
FILLING
1
Place the steam generator on a
stable ironing board or table,
with the iron resting on its stand.
2
Release the detachable water
tank by sliding outwards
A
.
3
Remove the anti-scale cartridge
by pulling upwards
B
.
4
Fill the tank to the ‘fill to here’
line with clean tap water
C
.
IN HARD WATER AREAS, THE
USE OF DISTILLED OR
DEMINERALISED WATER IS
RECOMMENDED.
WARNING: Never use battery
topping up fluid or water
containing any substances
like starch or sugar, or
defrosted water from a
refrigerator.
5
Re-install the anti-scale
cartridge and re-position the
water tank on the base unit and
push securely into place. Please
make sure the tank is secure
D
.
6
Always pour out any remaining
water after use.
Re-filling ‘in use’
1
When the water level becomes
low, the pump begins to emit a
clicking noise. This is due to air
being pumped instead of water
and is quite normal.
Refilling can be done whilst the
appliance is in operation. It is
not necessary to wait for the
appliance to cool down.
2
Slide out the water tank and fill
(see filling instructions).
Steam ironing
1
Unwind and straighten the
power cord
·
and supply cord
fi
.
2
Slide out the water tank and fill
(see filling instructions).
3
Connect the appliance to a
suitable mains outlet, and
switch on the socket. All 5 red
lights will flash once only and a
beep will be heard. Press the
power on switch
‚
and the unit
will turn on, it will default to Max
steam, and the “on” light will
flash red whilst heating up.
When ready for use, the light will
turn green.
4
Press the power switch again to
scroll through steam settings to
the “no steam” position (no
steam lights illuminated). Press
the power switch again to go to
the maximum steam position.
5
Turn the temperature dial on the
iron in a clockwise direction,
select dot-1, dot-2 or dot-3
according to the
recommendation of the garment
label.
6
The iron’s temperature indicator
light
›
goes off when the
required temperature is reached.
7
Depress the steam button
⁄
for
1 minute to clear the system of
air (first time use only) which will
be accompanied by a clicking
noise which is quite normal.
8
Begin first time ironing with an
old towel. Note: If you press the
steam button before the steam
generator reaches its required
temperature, a warning double
bleep will sound. It takes about
1 minute to reach the required
temperature.
9
Press the power button
‚
to
choose the steam level from
‘steam off’, ‘low steam’,
‘medium steam’ and ‘maximum
steam’.
10
The appliance is ready to use.
11
Press the steam button
⁄
for
steam ironing.
12
To switch the iron off, turn the
temperature dial on the iron in
an anti-clockwise direction to
‘Min’.
13
Depress and hold the power
switch for 2 seconds, the base
console will beep and switch to
off.
A
UK Helpline 0870 060 2614
Replacement Parts 0870 157 6645
Ireland Helpline 1800 409119
For details of other Morphy Richards products, please see our website:
C
D
B
42277 rev6:42288 rev1 08/04/2009 10:24 Page 5
