5
6
When the desired amount has been
dispensed, turn the Steam Control to Off
BEFORE
removing the mug from underneath
the Steam Wand.
5
Place an empty mug under the Steam Wand
(3)
. Turn the Steam Control
(2)
to On to start
dispensing hot water.
Follow steps 1,2,3 of ‘Using your coffee maker’
on page 3. Then refer to the following.
4
Slide the On/Off Switch
(10)
to On. The
Temperature Indicator Light
(9)
will stop
flashing when the coffee maker is ready.
•
Take your coffee maker out of the box and
remove the packaging.
•
Wash the detachable parts of the machine in
warm soapy water.
•
The first time you use your coffee maker,
operate with water only.
•
Occasionally air locks can be present before first
use. Please refer to troubleshooting guide
(page 8) to resolve.
The coffee maker can dispense two different
amounts of coffee. The coffee maker comes with
the following amounts set as the default settings.
One Cup - 50ml
Two Cup - 100ml
You can adjust these amounts for your own
personal preference by following these steps, (Up
to a maximum of 150ml for One Cup and 250ml
for Two Cup.)
1
Set up your coffee maker as normal following
steps 1-6 of ‘Using your automatic espresso’ on
page 3. Then refer to the following.
2
Slide and hold the One Cup
(6)
or Two Cup
(7)
Switch and keep pressed until the coffee maker
has dispensed the desired amount of coffee.
3
Release the switch to set the new dispensing
amount.
The new setting will be stored even if the coffee
maker is unplugged from the mains.
It is not possible to reset the amount back to the
original dispense amount. To adjust the amount
of coffee dispensed, repeat the adjustment
process again to create a new dispense amount.
Before first use
Adjusting the espresso
memory function
Using the Steam Wand
to dispense hot water
47155 rev3_Layout 1 02/09/2011 13:52 Page 5
