4
OPERATING THE
APPLIANCE
Assembly
WARNING: Do not plug in
the cleaner until it is
assembled.
1
Carefully unpack all of the
components.
2
Lift the cleaner body to the
upright position.
3
Remove the two upper screws
that are either side of the cable
storage and remove the dust
canister.
4
Insert the handle into the main
body of the cleaner and push
down firmly before re-fitting and
tightening the screws
A
.
5
Re-attach the dust canister.
IMPORTANT: The cleaner may
not operate correctly if the
canister is not securely in
position, so please ensure that
the handle is correctly fitted
before attaching the canister.
Using on carpets
1
Place the cleaner in it’s upright
position.
2
Release the mains cable by
turning the quick release cleat
Â
half-a-turn and extend the
cable fully.
3
Plug the cable into the mains
socket.
4
Step on the upright release
pedal
·
to release the handle
to the desired position.
5
Press the control switch on the
handle to setting ‘II’ (carpet).
•
Note: The beater bar will
automatically switch off when
the cleaner is parked upright.
IMPORTANT: To prevent damage
to carpets, never leave the
cleaner switched on in one
place for an extended period.
Using on hard floors
Follow steps
1
-
4
from the
instructions for ‘Using on
carpets’
5
Press the control switch on the
handle to ‘I’ (hardfloor)
NOTE: The beater bar does not
rotate with the power switch set
to ‘I’ (hardfloor)
Eco Switch
Slide the Eco Switch
‹
upwards to increase the suction
power or downward to decrease
suction
B
. This feature is most
useful when using the hose and
accessories. Use the minimum
setting when vacuuming
delicate fabrics/curtains etc.
When not using the hose, it is
advisable to keep the variable
slider set to maximum.
Using the hose and
attachments
1
Take the hose connector out of
the storage clip.
2
Pull down the hose connector
flap
È
and insert the hose
connector with it’s ‘mouth’
pointing upwards
C
.
IMPORTANT: Push the hose
connector fully in such that the
flap
È
latches on to the hose
connector
Ê
.
3
Add the required accessory to
the extension tubes or directly
to the tube connector
Ë
when
using the hose and tools.
IMPORTANT: Turning the cleaner
sideways helps prevent the
cleaner being pulled along by
the stretch hose.
IMPORTANT: Remove the hose
connector before returning to
floor cleaning with the main
nozzle. Push the flap down to
disengage the latch before
pulling out the connector.
A
È
Ê
FFoorr AAddvviiccee,, SSppaarreess oorr AAcccceessssoorriieess,, tteell::
00884455 007777 77770000 ((UUKK))
oorr
11880000 440099 111199 ((IIrreellaanndd))
B
C
73355 rev3 29/11/07 11:56 Page 4
