6
Using in upright mode
1
Turn the product On by using either the upright
On/Off button
(5)
or the handheld vacuum
cleaner On/Off button
(10)
.
The handheld vacuum cleaner power indicator
light
(11)
and the floor brush power indicator
light
(18)
will illuminate green.
NOTE: When the battery reduces to a pre-set
level the product will stop, the light will
extinguish and the product must be recharged.
2
If the motorised floor brush
(19)
is stalled, eg.
by a foreign object or if used on very deep pile
carpet, the floor brush power indicator light
(18)
will extinguish. Switch off, remove the cause of
the stall, and leave for a few minutes to allow
the floor nozzle protection to self reset.
To clean the motorised floor brush, you must
remove the handheld vacuum cleaner as shown
in ‘Handheld vacuum cleaning’, page 7. Then,
press the floor brush release button
(17)
and
pull the motorised floor brush away.
3
Turn the motorised floor brush over to inspect
the brush bar.
Using a coin, turn the locking button on the
brush bar cover anti-clockwise from the
position to the
position.
4
Remove the brush bar cover and lift the brush bar
out. Pull away any hairs or fibres from the brush
bar. If they are tightly wound around the brush,
carefully snip the fibres with scissors, being careful
not to damage the rotating brush bar, pull away
from the rotating brush bar and dispose of. Replace
the brush bar and cover in their original position.
Charging
Connect the mains plug
(21)
into the mains supply.
Locate the vacuum cleaner on to the charging
cradle
(15)
. The indicator light
(11)
will glow red
whilst charging and turn green when fully charged.
A full charge may take 5 hours.
When fully charged, the battery will stay charged
for many days, however, we recommend leaving the
cleaner continuously on trickle charge so the
batteries are always full.
VC732000MUK Rev1_Instruction Book 13/12/2013 14:57 Page 6
