•
Change display
G
:
Every week, one bar will
disappear to show the
remaining cartridge life. After
four weeks, all four bars will
disappear. This, and a flashing
arrow, indicate that the
cartridge should now be
changed. Insert a new cartridge
according to the instructions,
and reactivate the Memo as
described above.
REPLACING THE
BRITA MEMO
BRITA Memo - the electronic
cartridge exchange reminder
has a life of approximately 5
years. At the end of the Memo’s
life, please remember that it is
an electronic device and to
dispose of the Memo according
to all applicable provisions and
regulations. To remove the
exhausted Memo, place a
screwdriver in the notch next to
the Memo and push it out.
Please note that Memo should
not be removed for any other
reason than to dispose of it.
More information on the use of
BRITA filter cartridges and the
BRITA Memo can be found in
the BRITA information guide
supplied with the kettle.
Telephone our replacement
parts helpline for your new
BRITA Memo.
SWITCHING ON
You do not need to wait until the
water has filtered through before
boiling. Your Morphy Richards
filter kettle will boil and filter at
the same time, giving you boiled
BRITA filtered water quickly.
• Boil only as much water as you
need, as this saves electricity.
1
Place the filter kettle on the base
unit, ensuring the kettle locates
on to the 360° connector.
•
The 360° connector allows the
kettle to be located at any
position - ideal for left and right
handed users and convenient
positioning on a worktop.
2
Plug in and switch on at the wall
socket.
3
Switch the kettle on. The kettle
will illuminate internally.
4
When the water boils, the filter
kettle will switch off
automatically.
•
If you are using the kettle for the
first time, discard the water and
repeat once more.
•
To re-boil, switch to ON again. If
the kettle has just switched off,
wait a minute or so before
switching it back on again.
•
If you do not put in enough
water, or switch on the filter
kettle when it is empty, the
safety cut-out will switch off the
power automatically. If this
happens, refill and wait a few
minutes for the element to cool,
then use as normal.
5
Lift the filter kettle from the base
unit by the handle, ensuring you
hold the kettle level.
WARNING: Unless the
cartridge holder is fitted
correctly, the filter kettle may
not operate correctly and the
lid may not close and lock
securely.
WHEN TO
CHANGE YOUR
BRITA MAXTRA
CARTRIDGE
This depends on water quality
and the improvement required.
We recommend that you change
your cartridge after 4 weeks.
The electronic reminder on your
Morphy Richards water filter
kettle will remind you when to
change your cartridge.
BRITA filter cartridges conform
to the highest quality standards.
Raw materials and final
products are subject to stringent
internal and external controls.
BRITA filter cartridges are steam
sterilised. An independent
institute certifies the food grade
quality of BRITA water filters and
cartridges.
Great taste, less waste:
The BRITA MAXTRA cartridge is
100% recyclable. Please contact
BRITA customer care team for
advice on recycling schemes on
0844 742 4800
, or visit
www.brita.co.uk/recycle
H
.
HINTS AND TIPS
Cleaning and
maintenance
WARNING: Always disconnect
the plug from the mains and
allow the appliance to cool
before cleaning.
Wipe the outside with a damp
cloth.
IMPORTANT: Do not use
abrasive cleaners on the outside
of the appliance,
as they may scratch the surface.
HELPLINE
If you have any difficulty with
your appliance, do not hesitate
to call. We are more likely to be
able to help than the store
where you bought it.
If you require assistance on
using your BRITA MAXTRA filter
cartridge or BRITA Memo,
please call BRITA Customer
Care team on the telephone
number below
5
UK Helpline 0844 871 0954
Replacement Parts 0844 873 0720
Ireland Helpline 1800 409 119
H
G
43852 Rev2:x 23/10/2009 13:52 Page 1
