OPERATION PANELS A-51
5-21
Automatic In-Machine Tool Presetter OUT/IN Switches
[TOOL
PRESETTER
OUT/IN]
(Option)
The TOOL PRESETTER OUT/IN switches are provided
only on the machine equipped with an automatic in-
machine tool presetter.
The TOOL PRESETTER OUT/IN switches are provided
on the option panel, and can be used to manually move
the tool presetter out of or back into inside the chuck
cover.
For the procedure of using the automatic in-
machine tool presetter, refer to the
INSTRUCTION MANUAL FOR MACRO
PROGRAMMING published separately.
5-22
Automatic Power Shutoff Switch [AUTOMATIC POWER SHUTOFF] (Option)
The AUTOMATIC POWER SHUTOFF switch is used to
automatically validate the function that shuts the power off
after completion of machining.
The power supply circuit is automatically shut off when the
M02 (program end) or M30 (program end & rewind)
command in the program is read during automatic
operation.
When this switch is pressed again while the automatic
power shutoff function is valid, the automatic power
shutoff function becomes invalid.
The main switch is placed in the
TRIP
position after the power supply is automatically shut
off. To turn the power on again, place the main switch in the
OFF
position once and
then place it in the
ON
position.
When making the following settings, refer to the PC parameter list included in the
Ladder Diagrams.
•
To use an error output for shutting the power off when the automatic power
shutoff function is valid
•
To make the automatic power shutoff function valid all the time
TOOL PRESETTER
OUT
TOOL PRESETTER
IN
AUTOMATIC
POWER SHUTOFF
NOTE
