2-455
詳細説明
MACHINE OPERATIONS
24-2-2-1
G479
を使用して振れ止め台を移動させる
Moving the Steady Rest by Using G479
1)
ドアインタロック選択キースイッチを〔通常〕
にする。
2)
ドアを閉める。
3)
パネル操作選択キースイッチを
〔操作可〕
または
〔操作/編集可〕にする。
4)
モード選択ボタン
〔
MDI
〕を押し、
MDI
モー
ドを選択する。
5)
"G479 Q2
(
S1
)
"
を指令し、実行する。
[刃物台が振れ止め台と結合できる位置まで移動
し、停止]
[振れ止め台アンクランプ]
[振れ止め台から結合ピンが出て、刃物台と結
合]
[
〔振れ止め台クランプ〕ボタン内のランプ消灯]
6)
手動操作モードを選択する。
7)
Z
軸を移動させ、振れ止め台を任意の位置に移
動させる。
8)
〔振れ止め台クランプ〕ボタンを押す。
[振れ止め台クランプし、刃物台と分離]
[
〔振れ止め台クランプ〕ボタン内のランプが点
灯]
1)
Set the door interlock key-switch in the
[NORMAL]
position.
2)
Close the door.
3)
Turn the operation selection key-switch to
[Operation Enable]
or
[Operation & Edit Enable]
.
4)
Press the mode selection button
[MDI]
to select the
MDI mode.
5)
Specify and execute "G479 Q2 (or S1)".
[Turret moves to a position that allows connection with
the steady rest, and then stops.]
[The steady rest is unclamped.]
[Joint pin extends from the steady rest to connect to the
turret.]
[The indicator in the
[STEADY REST CLAMP]
button is
extinguished.]
6)
Select any of the manual operation modes.
7)
Move the Z-axis to locate the steady rest at any given
position.
8)
Press the
[STEADY REST CLAMP]
button.
[The steady rest is clamped to disconnect from the
turret.]
[The indicator in the
[STEADY REST CLAMP]
button is
illuminated.]
ここでは、アドレス
V
は指令しません。
G479
The address V must not be specified here.
For details on specifying the command G479,
Summary of Contents for MSX-850
Page 54: ...1 CHAPTER 1 BASIC OVERVIEW...
Page 170: ...2 CHAPTER 2 MACHINE OPERATIONS...