FOLDING CARD
PAPER JAMS
For best results, the card material should always be printed cross grain as this causes less
resistance when folding. Pre scoring of card stock is also recommended
By using the plug in perforator unit to deliver card, the problem of the stock curling will be
minimised. Set the backstop and side guide to suit the work. It is recommended that when
folding card, the machine is set to batch after twenty sheets, which will allow easy off loading.
For longer runs a optional rear delivery belt stacker (Assy. No. 9-09-01) is recommended to be
used.
In the event of a paper jam, the sensor will cut out the main switch. The main fold rollers are
linked to a clutch, which will prevent sheets continuing to feed.
If for some reason a piece of paper jams in the machine, remove and check inside the fold
plates. If there is paper jammed around the fold rollers take hold of a roller and wind them by
hand to remove the jam. If it is impossible to wind the roller by hand, remove the roller
assembly as described below. After clearing a paper jam, always check inside the fold plate
(see Fold Plate Section) to make sure no torn pieces of paper are jammed inside the plate.
ROLLER ASSEMBLY - REMOVAL
The complete roller assembly unit can be removed from the machine simply by unscrewing the
knobs (Y) on each side and taking hold of the rear roller and lifting out the unit. This is
beneficial to clear paper jams, and to clean the roller for maintenance.
With the roller assembly removed, the safety circuit prevents the machine from running. Clean
the rollers with a stiff brush between the grooves using the QD wash supplied with the
machine. Replace the roller unit in the reverse sequence.
Page 20
PAPER
Summary of Contents for Major
Page 7: ...Page 7 FOLDER Major BLANK PAGE ...
Page 19: ...Major Page 19 FOLDER ...
