INSTALLATION GUIDE
7
6
INSTALLATION GUIDE
Remove all packaging materials from the box and ensure all components and parts
are complete.
FAN ASSEMBLY
1. Assemble the pulley, bolt and pipe together as shown:
Cotter pin must be fixed into the bolt and bent.
Warning: May cause injuries if ceiling fan drops
WARNING
Do not use a modified pipe. Ensure the bolt is
attached securely to the pipe to prevent the ceiling fan from falling and causing
injuries.
4.Place the cap on to the motor shaft. Proceed to assemble
the pipe with the motor shaft and secure them in place
using the bolt, plain washer, spring washer, nut and cotter
pin. Complete the assembly by bending the cotter pin.
Cotter pin must be fixed into the bolt and bent.
Warning: May cause injuries if ceiling fan drops
Firmly tighten the bolt and nut using two
wrenches as shown.
Ensure the pipe has been fully tightened to the motor shaft.
Bolt tightening torque is 800 – 1200 Necm
(181.7 – 122. 4 Kgfecm).
Insufficient tightening may result in abnormal noise,
vibration or short appliance life.
Warning: May cause injuries if fan drops.
3.Pass the cord and safety wire through the pipe and insert
the cord spring. Remove the safety wire screw from the
motor shaft.
2.Slip the upper and lower canopies to the pipe.
Do not tighten the screws
Bolt
Pipe
B
Pulley
{
5.Connect the pipe cords to the motor terminal.
– First, connect EARTH wire {Green) to terminal "3"
– Second, connect NEUTRAL wire (Blue) to terminal "2"
– Lastly, connect LIVE wire (Brown) to terminal "1"
Ensure all terminals are connected correctly by
suitably qualified persons to avoid the risk of
electric shocks and other hazards.
6. Secure the cord as shown in the illustration using the insulock tie.
Do not secure the safety wire with the insulock tie.
Loose insulock tie and cords touching the motor are
unsafe. This will result in abnormal noise and may
cause ceiling fan to fall.
7.Assemble the fan blades onto the motor and secure it firmly in
place with the two (2) blade screws. Repeat until all fan blades
are assembled correctly.
Blades must be affixed correctly.
Incorrect assembly may not produce desired wind
results. Warning: May result in injuries if blades fall.
FAN SUSPENSION
•
Ceiling fan must be mounted above 2.5m from the floor
and at least 1m from the wall to the blade.
•
Warning: Contact with blades during fan operation may
result in injuries.
•
Ensure ceiling hook is able to support at least 20 times
the ceiling fan's weight.
•
Warning: Improper fan assembly can cause unstable
air flow and cause ceiling fan to wobble.
CAUTION
•
Ensure suspension hook is installed on concrete ceiling.
•
Do not install on plaster ceiling or any type of drywall ceilings.
•
Do not install inside dome ceiling
Terminal
1
2
LIVE
NEUTRAL
EARTH
Regulator
Connect to Regulator
“1”
,
”2”
,
”3”
3
{
Blade Screw
I
2.5M or more
B
Insulock Tic
Upper Canopy
Lower Canopy
Cord Spring
Cord
Safety Wire
P
Nut
Plain Washer
Spring Washer
Bolt
Safety Wire
Cap
Cotter Pin
Bolt
INCORRECT
POSITION
