9
8
INSTALLATION
OPERATING INSTRUCTIONS
FUNCTION ILLUSTRATION
1. TO SET THE CLOCK:
• When the appliance is connected to the power supply, the display will show 12:00.
• Touch the “TIMER” button and hold for 2-3 seconds.
• The “12” on the hour side will start flashing. Touch “LAMP (–)” and “SPEED (+)“ button to set hour.
• Then touch the “TIMER” button again and “00” on the minute side will start flashing.
• Touch “LAMP (–)” or “SPEED (+)“ to set the minute.
• Touch the “TIMER” button and time be set.
NOTE: The timer setting will need to be reset again in the event of a power interruption.
2. OPERATING THE APPLIANCE:
• Touch the “ON/DELAY” button. The appliance will enter standby mode.
• The blower has three speeds - “SLOW”, “MEDIUM” and “HIGH”. These three speeds can be toggled in-between by
the “+” button.
• The speed will start with “SLOW”, followed by “MEDIUM”, and then “HIGH”. The display will show “L-M-H”
NOTE: To switch off the appliance, touch the “ON/DELAY” button, all the lights will switch off immediately.
The fan will continue to operate for 5 minutes and the appliance will then switch off. However, continuously
touching the ON/DELAY button twice will switch off the appliance immediately.
3. OPERATING THE LIGHTS:
• The lights can be switched on by touching the “LIGHT” button.
• When the lights are turned on during the motor operation, touch the “ON/DELAY” button. The fan and lights will
continue to operate for 5 minutes before switching off.
CONTROL PANEL
6. EXHAUST PIPE CONNECTING TO THE WALL OUTSIDE
• The other head of exhaust pipe should be connected to the hole of wall outside (Diameter of the hole should
be 85mm)
7. CHECKING AND TESTING
• After installation, connect appliance to the power supply and turn on the appliance. Check if all functions of the
appliance are working normally, i.e.no vibration and no exhaust resistance.
MDH-915ST(IM)291216.qxp_Layout 1 12/29/16 5:01 PM Page 5
