1. Please use the specified gas type.
2. When using the hob, please ensure proper ventilation in the kitchen.
3. Installation and servicing should be carried out by authorized personnel only.
4. Use only low pressure regulator for this appliance. (as shown in figure 4)
6
7
CAUTION
INSTALLATION INSTRUCTIONS
OPERATION INSTRUCTIONS
1. This hob unit must be installed by a qualified technician to avoid hazard.
2. Cut the opening 680mm x 380mm (rounded edges with radius R50mm) as shown in
figure 1.
3. Use new hose and new hose clip (screw type) for installation of your hob unit. (as
shown in figure 2).
4. The glass top plate should fit the top of the bench properly.
5. After installation, test with soapy water to ensure no gas leakage. (as shown in
figure 3)
Low Pressure
Regulator
High Pressure
Regulator
Figure 4
680mm
380mm
R50
NOTE: Warranty void if
hole measurement for
installation of hob unit is not followed.
Gas Inlet Area
To Gas
Regulator
Figure 1
Figure 2
Figure 3
6. Hose should not exceed 2m.
7. Install the rubber hose.
8. Do not bend, twist or stretch the hose.
• The position of the corresponding gas burner is indicated on each control knob.
• The burner can be regulated with the corresponding control knob by using the
following setting:
HOB WITH ELECTRONIC IGNITION
• Insert the battery into the battery box provided.
(The battery box is located at the underside of the cooker).
• Turn on the gas supply.
• Depress the knob and turn it anti-clockwise 90º to maximum
flame position, a continuous clicking sound will be heard to
ignite the hob. Release the knob when the burner has been lit.
• Turning the knob clockwise to "OFF" position, a click sound will
be heard, the gas supply is shut off and the flame will distinguish.
FOR HOB WITH ELECTRONIC IGNITION & SAFETY DEVICE ONLY
• Electronic ignition & safety device is equipped with automatic shut off device. When the
flame is distinguished due to blowing of wind or overflow of spill, this protective device
will cut off the gas supply for safety protection.
• Insert the battery into the battery box provided (The battery box is located at the
underside of the cooker).
• Turn on the gas supply.
• Depress the knob and turn it anti-clockwise 90º to maximum flame position for 5-8
seconds, a continuous clicking sound will be heard to ignite the cooker. Release the
knob when the burner has been lit.
• Turning the knob clockwise to "OFF" position, a click sound will be heard, the gas
supply is shut off and the flame will distinguish.
CAUTION: if the flame extinguishes accidentally, turn off all gas supply and wait for 1
minute before attempting to re-ignite.