Meteo – Weather Sensor
Hardware: V4.0
Firmware: V4.4
In case the module is the last position on the bus, jumpers
should be placed according to Fig 1 A) to close the BUS
chain. In the case of bus lenght very long you may need only
put the jumper Term. In other situations should remain as in
Fig 1 B).
Fig 2:
Fig. 4:
7.
ADDRESSING AND CONFIGURATION
:
After connected and powered, perform the following steps:
1.
Open "Register modules" in the Mordomus software;
2.
Press address (Addressing) inside the module. The
Green LED will blink slowly and the red LED will
pulse once.
Note that after three minutes without having assigned a
new address, the module automatically returns to normal
mode
.
3.
Set the desired address in the window now displayed
on Software Mordomus.
8.
FUNCTIONING:
Led Code:
D5 Green LED ON:
Module powered;
D5 Green LED blinking briefly:
Module receiving data;
D5 Green LED blinking continuously:
Module awaiting
address;
D4 Red LED blinking
: module sending data.
Manual: Meteo-1706-EN
Page
2
/
2
