-
Press and release the Z-Wave button quickly several times once you put the controller in
the inclusion mode to ensure the command has gone through
-
Put your controller in the EXCLUSION mode and press and release the Z-Wave button
quickly 3 times, then try adding it to your network again
Z-WAVE
EXCLUSION
1. Bring the siren within 3 feet from your Z-Wave gateway controller
2. Put your Z-Wave controller in exclusion/unpairing mode
3. Press and release the Z-Wave button on the siren THREE TIMES quickly
4. The device should disappear from your controller's device list
Please repeat the process following all steps carefully if first attempt is unsuccessful
FACTORY
RESET
If your primary controller is missing or inoperable, you may need to reset the device to
factory settings. To complete the process, press and hold the Z-Wave button for 10 seconds.
NOTE: All previously recorded activity and custom settings will be erased from the siren
’s
memory.
ASSOCIATION
Once the Z-Wave siren is added to your network, you are able to trigger it with other
components from your network, as well as control and monitor its activity from your mobile
device, or computer.
Depending on your Z-Wave gateway's home automation software capabilities, you may be
able to associate your indoor siren in groups with other Z-Wave devices to schedule scenes
and create events. Indoor siren supports Group 1 with up to five devices for lifeline
communication (Group 2-5 is not supported).
Please refer to your controller's user guide for advanced programming instructions as they
are a little different for every software.
MOUNTING
Find the best spot for your Z-Wave indoor siren - a corner in the living room, garage ceiling,
or anywhere else you see fit. Use the 2 screws included in the box to fix the mounting
bracket to flat surface of your choice.
Once the bracket is securely installed, carefully slide the siren onto the bracket and position
it by tilting it to either side, upwards, or downwards.
WARNING
-
This product should be installed indoors upon completion of any renovations
-
Prior to installation, the device should be stored in a dry, dust- and mold-proof place
-
Do not install the siren in a place with direct sun exposure, high temperature or humidity
-
Keep away from chemicals, water, and dust
-
Ensure the device is never close to any heat source or open flame to prevent fire
-
Ensure the device is connected to an electric power source that does not exceed the
maximum load power
3
www.mordomus.com
