11
© 2021 Maka Technologies Group. All Rights Reserved.
Getting Started
Operation of your Marbella AirPump AX1
Switch Mode
This function is to let you change the mode of pump require to use on which type of item.
1.
Turn on Marbella air pump AX1
–
Press and hold for 2 second on button to turn on device.
2.
Press on mode button (Refer figure 1) twice to change the mode. Continue to press the same button
to switch mode till you wish to set it on. Refer to figure 2 below
3.
Press and hold on mode button for 2 second and pressure mode will start blinking. Press again on the
button to switch mode (PSI/BAR/KPA/Kg/cm²). Refer to figure 3 below
4.
Once mode is set, the blinking mode will stop and next step is to set the pressure capacity (refer to
Operation
for instruction)
Noted : The air pump will shut down automatically if there is no operation within 60 seconds
after it is started. You can use LED light no matter whether the product is on / off.
Operation (Vehicle/Motorcycle/Bicycle/Ball)
This operation will let you know how to select the right type of mode and setting of the pressure in-order to have
a better and correct usage.
1.
Turn on Marbella air pump AX1
–
Press and hold for 2 second on button to turn on device.
2.
Set mode type of mode (refer to Switch Mode on setting) based on what you will use the device for
–
Car / Motorcycle / Bicycle or Ball.
3.
Set the pressure by pressing on (+) or (-) switch once. Blinking led number will appear and press (+) or
(-) to set to the right pressure. Blinking led number stop and back to main led display (0.00) after 2sec
when no operation detected.
4.
Attach the inflation to the tire (For car and motorcycle
–
tube is origin attach to pump) or item (ball or
other inflatable item
–
Require to attach a nozzle provided to the origin tube).
5.
Pressure indicator will show the pressure of the tire or item pressure when connected. Press the on/off
switch to start. For inflatable item you may require to start and stop manually if pressure is unavailable.
6.
Once pressure reach the pressure point set, pump will stop operate. Remove the inflator accordingly
from the tire or item. Proceed to the next and goes on.
(Noted : Do know the pressure mode and what capacity of the air needed to pump before setting
the type of mode as device will be shut down in 60sec when no operation detected)
