Routine Service and Maintenance
4.9
New Machine Brake-in Maintenance Procedures
Do the following after the first 20 operating hours for a new machine only.
1. Change engine oil - Refer to the engine manual for the proper engine oil changing
instructions.
2.
Change engine oil filter, which is located on the left side of the engine. Refer to the engine
manual for the proper engine oil filter changing instructions. The oil filter is located at the
front of the engine (Item 1,
Figure 4–10
).
Figure 4-10 Engine Oil Filter
3.
Change the hydraulic filter. See Service Manual and
Figure 4–11
.
a. Remove the front cover (Item 3,
Figure 4–11
) to enable access to the filter assembly
(Item 11,
Figure 4–11
).
b. Remove the three bolts (Item 6,
Figure 4–11
) holding the filter cover (Item 7,
Figure
4–11
) in place.
Press downwards on filter cover to relieve the upwards pressure from the spring.
c.
Remove the filter cover and spring (Item 8,
Figure 4–11
).
d.
Remove the filter element (Item 9,
Figure 4–11
) and replace with a new filter element.
e.
Inspect the filter cover O-ring (Item 10,
Figure 4–11
) for any signs of wear or damage.
Replace as needed.
f.
Reinstall spring and filter cover.
Make sure that the O-ring is properly seated in the filter cover.
g. Start and run the engine for about 30 seconds.
1
NOTICE
NOTICE
