Remove all packaging before use and check to make sure that the
appliance is In perfect condition. If you have any doubts do not
use the appliance and call your supplier.
Some parts on the appliance are protected by a plastic film. This
protective film must be removed before the appliance is used. We
recommend carefully slitting the plastic film along the edges with a
sharp knife or pin.
The packaging materials should carefully discarded and not left
within easy reach of children as they are a potential safety hazard.
Your hob can be fitted to any worktop with a thickness of 40 to
50 mm, accordance with No overhanging surface or cooker hood
should be closer to the hotplate than 750 mm.
Fix in position in fig, 4. If fitting a 600 mm bridging unit above the
700 mm hob unit, the sides of adjacent cabinets may be lower
than 760 mm down to 334 mm provided they are resistant to heat
and steam.
The hob has a speciaf seal which prevents liquid from entering the
cabinet Follow these instructions in order to correctly apply this
seal:
Detach the seals from their backing, that the transparent
protection still adheres to the seal itself.
Turn over the hob and correctly position seal *E* (fig. 5) under
the edge of the hob itself, so that the outer part of the seal itself
perfectly matches the outer edge of the hob. The ends of the
strips must fit together without overlapping. Evenly and securely
fix the seal to the hob, pressing it firmly in place.
UNPACKING THE
APPLIANCE
INSTALLING AND FIXING
THE HOB
A
B
C
D
E
F
G
557
477
65
62
150 min.
90 min.
750 min.
E
E
Fig 5
Fig 4
E
E
A
D
B
C
F
G
6
