www.m o p e c .c o m
(800) 362- 8491
info @ m o p e c .c o m
Cleaning and Maintenance
DISINFECTING AND CLEANING STAINLESS STEEL SURFACES
All stainless steel surfaces can be cleaned with soap and water, which will remove debris.
The stainless steel surfaces can be disinfected with a non caustic disinfectant. We suggest
using BE045 Path Cloud or BE047 Bench Wipe for cleaning purposes. We recommend you
NOT USE a bleach solution to clean your unit. Bleach will eventually erode stainless steel if
not thoroughly rinsed. The use of chlorine bleach will VOID THE STAINLESS STEEL
WARRANTY
During the cleaning we suggest wiping the surface in the same direction as the satin finish
which will help lift up dirt from the grain finish.
Most scratches can be removed simply by utilizing a "non-metallic" abrasive pad and rubbing
in the same direction as the satin finish.
Since most abrasive pads vary from one supply to another, we suggest rubbing the entire
surface to blend the scratch and blend the balance of the surface.
Plexi-glass surfaces will scratch if cleaned with an unsuitable cleaner and improper cleaning.
Many plastic cleaners are available and we suggest using one. Wipe dry with a clean,
absorbent cloth or paper towel turning often
CLEAR DISPOSAL JAMS
The accidental entry of foreign material will cause any Waste Disposal unit to jam. To free
jammed material, follow these steps to avoid personal injury.
1. Turn off Waste Disposal and shut off cold water.
2. Insert one end of your Self Service Wrench, provided with your Waste Disposal, into the
center hole of the bottom of the disposer.
3. Work the wrench back and forth until it moves freely for at least one complete revolution.
Remove the wrench before restarting the Disposal.
4. Wait 3 to 5 minutes to allow Waste Disposal motor to cool and then push the reset button.
Be sure the main Disposal control switch is in the OFF position before pressing the reset
button.
