11
Install SKREEM Interface
A. Remove the screw securing the
SKREEM module to the
ignition cylinder. Unplug and slide
the assembly off of the ignition
cylinder.
B. Following the directions on the sup-
plied ampule of adhesive primer. Ap-
ply a thin coating of primer to the en-
tire SKREEM transceiver antenna coil.
Allow the primer to dry for 5 minutes
before proceeding to the next step.
Note: Use goggles and gloves to
protect yourself from any acciden-
tal contact.
C. Remove backing from one side of the
supplied two-way tape and apply tape
around the SKREEM transceiver an-
tenna coil.
D. Remove the remaining backing on
the tape and position the antenna
loop on the tape around the
SKREEM transceiver antenna coil,
with the stripe side facing out to-
ward the key opening. Press down
on antenna coil to ensure a strong
bond.
E. Using a supplied wire tie, secure
the antenna coil.
F. Re-install the SKREEM module to
the ignition cylinder and secure with
the screw. Make sure to plug the
connector back into the SKREEM
module.
