MOOSE C1205DP, User Manual, Page: 4 / 9

www.moosesound.com
4
Connections and Controls
Cabling connections
Please refer to the following scheme and instructions:
1. INPUT: Balanced XLR/JACK signal input (hybrid Combo
connector) for connection of an external audio source (e.g.,
mixer).
2. PC: Ethernet cable (RJ45) input to allow/establish
communication between the built-in DSP and the software
supplied.
3. LINK: Balanced signal output (XLR 3p) for connection of
another C605DP or C1205DP active column speaker.
4. OUTPUT: Speaker output (spring terminals) for
connection of another passive C605DP or C1205DP, 100W
and Min. load: 8Ohm. There is an ‘’extra’’ amplifier inside
capable of driving another passive version of the C605DP or
C1205DP speaker.
5. MAINS IN: IEC socket, AC 230V - 50~60Hz.
6. POWER ON: Illuminated on/off switch. Before switching
the system on or off, always adjust the volume to zero.
Content: the package includes a RJ45 ethernet cable, a
small interface PCB and a mini CD with installation
software.
1
2
3
4
5 5
6 6
OUTPUT OUTPUT
Ext. Speaker Ext. Speaker
8 Ohm 8 Ohm
100W RMS 100W RMS
FUSE F 2A FUSE F 2A
POWER ON POWER ON
INPUT INPUT
LINK LINK
PC PC
Digital Directivity Control Digital Directivity Control
3 Way Digital Active System 3 Way Digital Active System
Digital Amplifier - Class D Digital Amplifier - Class D
Built-in Digital Signal Processor Built-in Digital Signal Processor
C804DP C804DP
C605DP C1205DP
CAUTION CAUTION
RISK OF ELECTRIC SHOCK. DO NOT OPEN. RISK OF ELECTRIC SHOCK. DO NOT OPEN.
To prevent electrical shock do not remove To prevent electrical shock do not remove
the cover. No user serviceable parts inside. the cover. No user serviceable parts inside.
Refer service to qualifi ed personnel only. Refer service to qualifi ed personnel only.
www.moosesound.com www.moosesound.com
MAINS MAINS
230V AC 230V AC
50HZ 50HZ
70VA 70VA
Active column speaker, DSP
C605DP/C1205DP
The below procedures are mandatory before start using the software.
1. Pick up the small PCB with RJ45 to RS232 included in the package.
2. Connect the ethernet cable between the RJ45 - PC input (2) on the rear panel of the speaker and the small
PCB RJ45 input.
3. Pick up the RS232 to USB cable adapter and connect the RS232 connector to the Rs232 output connector on
the small PCB.
4. . Connect the USB connector to your computer that will control the speaker.
5. Turn ON the power amplifier by applying the ON/OFF power switch.
MAN174_0