DCA
Page 22
PC DCA’s slide into card slots in Moore Industries’
nineteen-inch card racks, the SMR and RMR. Each
DCA has individual contacts on its rear edge that
mate with an edge connector at the back of the rack.
Maintenance
Once the DCA is properly calibrated and installed, it
will operate indefinitely. No further adjustments
should be necessary, unless the unit is moved, or the
process input changes.
It is recommended that the unit terminals be checked
periodically for signs of oxidation or looseness.
If a problem develops with the performance of the
DCA, remove the unit from service and recalibrate.
Refer to the Calibration Section of this manual for
instructions.
Any units found to be performing below specifications
after a recalibration should be returned to the factory
immediately. Instructions for unit return can be found
on the back cover of this manual.
Customers may also contact the friendly folks in
Moore Industries’ Customer Service Department at 1-
800-999-2900 for technical assistance.
