380D
Nēo
Series
Remote Control Operation
The
Nēo 380D
Digital-to-Analog Converter uses the
‘CRM-2’
full-function
remote control (figure 6). It operates on the Philips RC-5 communication
protocol and is can be used with other Simaudio MOON components.
The
‘CRM-2’
remote uses two AA batteries (included). To install them, simply
slide the back plate off in the direction of the arrow; insert the batteries in the
correct direction and then replace the back plate.
To engage the
‘CRM-2’
remote for use with the
Nēo 380D
,
you must first
press the button labeled
D/A
.
The
POWER
button located on the upper left will switch the Digital-to-Analog
Converter to either ‘Standby’ or ‘On’ mode.
The
DISPLAY
button turns the front panel display on and off.
The 2 buttons labelled
◄
INPUT
►
allow you to sequentially scroll, either
backwards or forwards, through all eight (8) available inputs. For example, to
switch from “D4” to “D1” you may press either
◄
INPUT
three (3) times or
INPUT
►
five (5) times. Pressing and holding down either of these buttons
results in only a single change to the selected input.
The
MUTE
button turns off the output volume. Pressing the “Mute” button a
second time will reinstate the output volume level back to its current setting.
For
Nēo
380D’s equipped with the optional volume control:
The 2 buttons labelled
▼
VOL
▲
allow you to control the volume level.
Pressing
▼
VOL
results in a decrease in the volume level; Pressing
VOL
▲
results in an increase in the volume level. You may either press and hold these
buttons down or press them briefly to make volume adjustments.
NOTE:
The buttons labelled
◄
BAL
►
don’t affect the operation of the
380D
.
Figure 3: CRM-2 Remote Control
.
12