220i Integrated Amplifier
Remote Control Operation (cont’d)
The
N
ē
o 220i
Integrated Amplifier uses the
‘CRM-2’
full-function remote control
(figure 4). It operates on the Philips RC-5 communication protocol and is can be
used with other Simaudio MOON components.
The
‘CRM-2’
remote uses two AA batteries (included). To install them, simply slide
the back plate off in the direction of the arrow; insert the batteries in the correct
direction and then replace the back plate.
To engage the
‘CRM-2’
remote for use with the
N
ē
o 220i
Integrated Amplifier,
you must first press the button labeled
AMP
.
The
POWER
button located on the upper left will switch the integrated amplifier to
either ‘Standby’ or ‘On’ mode.
The 2 buttons labelled
◄
INPUT
►
allow you to sequentially scroll, either
backwards or forwards, through all six (6) available inputs. For example, to switch
from the “CD” to the “VIDEO” input you may press either
◄
INPUT three (3)
times or INPUT
►
three (3) times. Pressing and holding down either of
these buttons results in only a single change to the selected input.
The 2 buttons labelled
▼
VOL
▲
allow you to control the volume level. Pressing
▼
VOL
results in a decrease in the volume level; Pressing
VOL
▲
results in an
increase in the volume level. You may either press and hold these buttons down or
press them briefly to make volume adjustments.
The
MUTE
button turns off the output volume. Pressing the “Mute” button a
second time will reinstate the output volume level back to its current setting.
NOTE:
The 2 buttons labelled
◄
BAL
►
and the
DISPLAY
button don’t affect the
operation of the
220i
.
Figure 4: CRM-2 Remote Control
____________________________________________________________________________________
11