moog
MSD Servo Drive DC-AC Operation Manual
9
Id.-No.: CA97554-001 Date: 06/2012
[
]
Safety
1 Safety
1.1 For your safety
The instructions set out below should be read through prior to initial commissioning
in order to prevent injury and/or damage to property. The safety instructions must be
followed at all times.
1.1.1 Read the Operation Manual first!
1.
Read the Operation Manual first!
•
Follow the safety instructions!
•
Refer to the user information!
Electric drives are dangerous:
•
Electrical voltages 230 V AC / 320 V DC to 480 V AC / 770 V DC
Dangerously high voltages ≥50 V may still be present
10 minutes after the power is cut (capacitor charge).
So check that the power has been cut!
•
Rotating parts
•
Hot surfaces
Protection against magnetic and/or electromagnetic fields during installa-
tion and operation.
•
Persons fitted with heart pacemakers, metallic implants and hearing
aids etc. must not be allowed access to the following areas:
− Areas where drive systems are installed, repaired and operated.
− Areas where motors are installed, repaired and operated. Motors
with permanent magnets pose a particular hazard.
NOTE:
If it is necessary to access such areas, suitability to do so must be
determined beforehand by a doctor.
Your qualification:
•
In order to prevent personal injury and damage to property, only
personnel with electrical engineering qualifications may work on the
device.
•
The said qualified personnel must be familiar with the contents of the
Operation Manual (cf. IEC 364, DIN VDE 0100).
•
Awareness of national accident prevention regulations (e.g. BGV A3 in
Germany).
During intsallation observe the following instructions:
•
Always comply with the connection conditions and technical specifica-
tions.
•
Comply with the standards for electrical installations, such as regarding
wire cross-section, protective conductor and ground connections.
•
Do not touch electronic components and contacts (electrostatic dis-
charge may destroy components).
Table 1.1 Safety instructions
