Programmable Multi-Axis Servo Drive Power Supply Unit Operation Manual
ID no.: CA97556-001 Date: 03/2015
moog
9
Safety
1
Safety
1.1
Measures for your safety
The instructions set out below should be read through prior to initial commissioning
in order to prevent injury and/or damage to property. The safety instructions must be
followed at all times.
1.1.1
Read the Operation Manual first!
Read the Operation Manual and the reference documents first!
•
Follow the safety instructions!
•
Refer to the user information!
Electric drives are dangerous:
•
Electrical voltages 230 V AC / 320 V DC to 480 V AC / 770 V DC
Dangerously high voltages ≥ 50 V (capacitor charge) may still be present 10 minutes after
the power is cut to the size 5 and size 6A. The discharge time depends on the number of
drives connected to the multi-axis system. So check that no voltage is connected!
•
Rotating parts
•
Hot surfaces
Risk of burning by hot components!
•
The heat sink of the inverter, the choke, the transformer, the filters and the fuses become
very hot in operation.
− Make sure the components have cooled down to ambient temperature before carrying
out any work. Or wear protective clothing and gloves when working close to hot
components.
Risk of burning by hot coolant!
•
The coolant gets hot during operation. Make sure the coolant has cooled down to ambient
temperature before carrying out any work.
1.
Protection against magnetic and/or electromagnetic fields during installation and operation.
•
Persons fitted with heart pacemakers, metallic implants and hearing aids etc. must not be
allowed access to the following areas:
− Areas where drive systems are installed, repaired and operated.
− Areas where motors are installed, repaired and operated. Motors with permanent
magnets pose a particular hazard.
NOTE:
If it is necessary to access such areas, suitability to do so must be determined beforehand by a
doctor
Your qualification:
•
In order to prevent personal injury and damage to property, only personnel with electrical
engineering qualifications may work on the device.
•
The said qualified personnel must be familiar with the contents of the Operation Manual
(see IEC 364, DIN VDE 0100).
•
Knowledge of the national accident prevention regulations (e.g. BGV A3 in Germany)
U
V
N
L+
RB
L-
L3
L2
L1
U
V
N
L+
RB
L-
L3
L2
L1
During installation observe the following instructions:
•
Always comply with the connection conditions and technical specifications.
•
Comply with the standards for electrical installations, such as regarding wire cross-section,
PE conductor and earth connections.
•
Do not touch electronic components and contacts (electrostatic discharge may destroy
components).
Table 1.1 Safety precautions
