Mounting Holes
Support Arm Holes
Support Arms Rotate Out
Support Wires
4. Remove the trim ring/dome assembly by pulling on the outside
of the trim ring. The ring and dome are connected by three flat
springs, which press against the side of the housing and lock into
(3) cutouts.
5. Run electrical cable and video leads into the housing through the
conduit knock-out.
6. With the (3) support arms rotated to the inside, slide the housing
into the pre-cut hole (Figure 1).
CAMERAS VOLTAGE CURRENT POWER
1 24 VAC/VDC 102mA 2.5W
2 24 VAC/VDC 210mA 5W
3 24 VAC/VDC 331mA 7.9W
4 24 VAC/VDC 487mA 10.9W
Use the formula below to select the correct power supply for
cameras connected in parallel (positive to positive, negative to
negative):
Total current for a 24 VAC system:
TOTAL CURRENT = (202mA x total number of cameras)
Note: 202mA is camera plus power supply
CABLE AND POWER GUIDELINES (Detailed info on Page 11)
This chart shows the proper current needed for power supplies for
Q-View™ cameras. Use Class 2 Power only. Input voltage must
be 24 VAC/VDC.
PRODUCT INSTRUCTIONS
REVISION DATE: July 6, 2004
81-IN5258-07064
QMR Ceiling Mount Dome
QMR(T/C)X-XXXX
Figure 1
Figure 2
7. With the bottom flange pressed up against the ceiling, rotate the
support arms to the outside, the arms will fall to the back side of
the ceiling. Tighten the (3) support arm screws (Figure 2).
8. If the housing is going into a ceiling where the support arms will
not work, secure the housing by running bolts into the solid ceiling
through the mounting holes in the bottom flange (Figure 1).
9. For added support, run support wires from a secure structure to
the two slots provided on the top of the housing (Figure 3).
HOUSING INSTALLATION
1. Carefully remove all equipment from the box.
2. Place the 11 1/8" template provided with the unit at the desired
location on the ceiling. Trace around the template, then cut a hole
in the ceiling following the trace lines.
3. Remove the desired conduit knock-out from the top of the QMR
housing.
Figure 3
TABLE OF CONTENTS
Cable and Power Guidelines
1, 11
Electrical Specifications
1
Housing Installation
1
Wiring
2
Camera Adjustment
2
Camera Focusing
2
Camera Settings
Black/White
2
Color
3
Completion of Installation
3
NVT Instructions
3
Exploded View
5
Warranty Information
6
Service and Safeguard Information 7
Troubleshooting
8
