- 2 -
Roll Tool Over
Buckle
Turn handle Coun ter clock wise
for Back-off during Rollover
6.
Pull cutting handle to cut the band.
7.
Remove tool, holding stub of band down with thumb.
8.
Clinch stub by hammering down buck le ears, com plet ing
Band-It clamp.
3.
Place band in the open slot of the tool nose and slide in.
With thumb on band grip per lever, apply tension by turn-
ing handle of tool. After tension is created, it is no longer
necessary to hold band gripper lever as it locks itself
under tension.
4.
Place fi nger on Band-It Band at buck le while tensioning
with tool han dle, When you feel Band-It Band stop mov ing
through buckle as you are turning han dle, max i mum pres-
sure is being exerted by the Band-It Band around object
being clamped. Stop turning han dle.
5.
Roll tool over buckle, backing off with tension handle
throughout entire rolling operation. Failure to back off
with ten sion handle throughout entire course of roll may
result in breaking of band. There is no loss of tension, as
band released is used up in the bend.
Handle Turned
Clockwise For
Tightening
Cutting handle
Hand-Schneidheble
