GETTING READY TO SEW
13
5. Then pull the thread further down and around the bottom part
of the take up lever cover.
6. At the top of this movement, pass the thread from right to the
left through the slotted eye of the take-up lever and then
downwards again.
7. Snap the thread into the down thread guide and guide the
thread through the wire loop.
Pull the end of the thread through the needle from front to
rear, and pull out about 10 cm of thread.
Use the needle threader to thread the needle. (See the next
page for instruction.)
4. Pull the thread forward and down. This operation pulls the
thread into the thread tension.
3. Guide the thread around another thread guide. Snap the
thread into it then pull the thread through the pre-tension
2. Pull the thread from the spool and snap the thread into the
upper thread guide.
