6
INSTALLATION AND OPERATING CONDITIONS OF
THE APPLIANCE
Installation before using the appliance for the first time
It is recommended to prepare the appliance for operation with a helper.
•
Remove package. Lift the appliance away from foamed polystyrene base. Tear off
adhesive tapes.
•
When positioning the appliance in chosen location, it will move more easily into
position if you lift the front a little and incline it backward, allowing it to roll on its
casters. Moving or positioning the appliance do not tilt it by more than 40° from the
vertical position.
When placing, moving, lifting the appliance, do not hold the door handles,
do not pull the condenser at the rear part of the refrigerator and do not touch
the compressor unit.
•
Remove all red-coloured parts from the
shelves. Tear away the adhesive tapes from
the door trays – they are intended only for
the transport of the appliance.
NOTE. When you open the freezer
compartment door a little red packing detail will fall out – IT IS FOR
TRANSPORTATION PURPOSES ONLY.
•
Take two supports 1 from the bag and insert
them into the guides 2 at the top back part of the
appliance (see picture).
•
If the appliance is brought in from the cold
(temperature is not higher than +12 °C), you
should wait for two hours before connecting it to the mains.
The appliance should not be connected to the mains until all packing and
transport materials aren’t removed. Suitably dispose the packaging material.
Connection to the mains
•
This appliance should be connected to AC 220-240V 50Hz supply socket. The
socket must be fitted properly, and must be supplied with an earthling conduit and
a 10A fuse. It is a legal requirement that the appliance is properly earthed.
The manufacturer will not be held liable for any damage or injury which may result
from the failure to fulfil this requirement.
•
Do not use adapters, multiple sockets and two-wire extension leads. If it is necessary
to use the extension lead, it must be equipped with a protection ring and a single
socket and must have a VDE/GS safety certificate.
•
If an extension lead is used (with a protection ring and safety certificate), its socket
must be located at a safe distance, away from the sinks, and must not be in a place
where it could be flooded by water or waste water.
•
When positioning the appliance, be careful that the electrical cord isn’t squeezed in
order to avoid its damage. Do not store heavy objects such as cooling devices,
furniture or other domestic devices next the appliance in such a way that they could
squeeze and damage the electrical cord. This can cause a short circuit and a fire.
