EN - 8
1.2 Installation warnings
Before using your fridge for the first time,
please pay attention to the following points:
•
The operating voltage for your fridge is
220-240 V at 50Hz.
•
The plug must be accessible after
installation.
• Your fridge may have an odour when it is
operated for the first time. This is normal
and the odour will fade when your fridge
starts to cool.
•
Before connecting your fridge, ensure
that the information on the data plate
(voltage and connected load) matches
that of the mains electricity supply. If in
doubt, consult a qualified electrician.
• Insert the plug into a socket with an
efficient ground connection. If the socket
has no ground contact or the plug does
not match, we recommend you consult a
qualified electrician for assistance.
•
The appliance must be connected
with a properly installed fused socket.
The power supply (AC) and voltage at
the operating point must match with
the details on the name plate of the
appliance (the name plate is located on
the inside left of the appliance).
•
We do not accept responsibility for any
damages that occur due to ungrounded
usage.
• Place your fridge where it will not be
exposed to direct sunlight.
•
Your fridge must never be used outdoors
or exposed to rain.
•
Your appliance must be at least 50 cm
away from stoves, gas ovens and heater
cores, and at least 5 cm away from
electrical ovens.
• If your fridge is placed next to a deep
freezer, there must be at least 2 cm
between them to prevent humidity
forming on the outer surface.
•
Do not cover the body or top of fridge
with lace. This will affect the performance
of your fridge.
•
Clearance of at least 150 mm is required
at the top of your appliance. Do not place
anything on top of your appliance.
•
Do not place heavy items on the
appliance.
•
Clean the appliance thoroughly before
use (see Cleaning and Maintenance).
• Before using your fridge, wipe all parts
with a solution of warm water and a
teaspoon of sodium bicarbonate. Then,
rinse with clean water and dry. Return all
parts to the fridge after cleaning.
•
The installation procedure into a kitchen
unit is given in the installation manual.
This product is intended to be used in
proper kitchen units only.
• Install the two plastic distance guides (the
parts on the black vanes
-condenser- at the rear)
by turning it 90° (as
shown in the figure) to
prevent the condenser
from touching the wall.
• The distance between
the appliance and back wall must be a
maximum of 75 mm.
1.3 During Usage
•
Do not connect your fridge to the mains
electricity supply using an extension lead.
•
Do not use damaged, torn or old plugs.
•
Do not pull, bend or damage the cord.
•
Do not use plug adapter.
•
This appliance is designed for use by
adults. Do not allow children to play with
the appliance or hang off the door.
• Never touch the power cord/plug with wet
hands. This may cause a short circuit or
electric shock.
• Do not place explosive or flammable
material in your fridge. Place drinks with
high alcohol content vertically in the
fridge compartment and make sure their
tops are tightly closed.
Old and Out-of-order Fridges
•
If your old fridge or freezer has a
lock, break or remove the lock before
discarding it, because children may
