EN -16-
Installation instructions and door reversibility
Installation
! Before installation, read the instructions carefully.
! Fit the refrigerator/freezer in stable kitchen units only.
! If necessary, reverse the door according to instructions.
1. See fig.A for the necessary attachment components.
2. Insert trim
flap
1
into slot and screw by
screws
6
. (fig.D)
3. Pass the power cord through ventilation shaft and position it so that the appliance could
be easily plugged in once it has been installed. (fig.B - fig.C)
4. Take out the
trim gasket
4
located on the side panel of the appliance and stick it on
reverse side of the door hinges of the appliance. (fig.D - fig.E)
5. Raise the appliance and slide into the kitchen unit.
6. Push the appliance to the reverse side of the door hinges providing that the
trim gasket
2
covers the space between the appliance and the kitchen unit.
7. Align the front feet with front surface of the kitchen unit. (fig.F)
8. Screw the front feet by using
screws
5
. (fig.F)
9. Screw
trim flap
1
to kitchen unit using
screws
5
. (fig.G)
10. Screw
guides
3
to appliance door with
screws
6
. (fig.H)
11. Lean appliance door to unit door as it is opened at right angle.
12. Slide
rails
4
into
guides
3
aligning the
groove
. (fig.H)
13. Screw the
rails
4
to the unit door with
screws
5
. (fig.H)
14. Set 1~2 mm gap on handle side between unit itself and unit door by adjusting
guides
3
.
That is vital for appliance performance. (fig.H)
