EN -12-
PART - 5.
TRANSPORTATION AND CHANGING OF
INSTALLATION POSITION
Transportation and changing of installation position
•
The original packages and foamed polystyrene (PS) can be retained if required.
•
During transportation, the appliance should be secured with a wide string or a strong
rope. The instructions written on the corrugated box must be followed while transporting.
•
Before transporting or changing the installation position,
all the moving objects (ie,drawers, flaps…) should be
taken out or fixed with bands in order to prevent them
from getting damaged.
Defrosting the freezer
WARNING:
Never use sharp metal tools, unless recommended by manufacturer, for this
operation as they can damage the refrigeration circuit.
After a period of time, frost will build up in certain areas in the freezer compartment.
The frost accumulated in the freezer compartment should be removed periodically
(use the plastic scraper if available).
Complete defrosting will become necessary if the frost layer exceeds 3-5 mm in order to
maintain the efficiency of the freezer.
• The day before you defrost, set the thermostat dial to position “5” to freeze the food
completely (Recommendation).
•
When defrosting frozen foods, food should be wrapped in several layers of paper and
kept in a cool place. The inevitable rise in temperature will shorten its storage life.
Remember to use this food within a relatively short period of time.
• Set the thermostat knob to position “•” and switch off the appliance.
•
Leave the door open to accelerate defrosting. Remove any water from the compartment.
•
This appliance has a special drain system.
1. Pull out the
bottom drawer
A
of the freezer
compartment. Put it on the floor and align it to
the front of the cabinet.
2. Pull out the
drain pipe
B
located on the back
wall of the freezer compartment. Then, place it
in the groove on the front side of the appliance
floor.
3.
If there is still water on the freezer floor, you
can remove it by using a sponge.
•
Clean the interior by hand with lukewarm water
and a little detergent. Never use abrasive
products or aggressive cleaning agents.
•
Dry the inside of the unit, plug it into the mains and
set the thermostat knob to position “5”. After 24
hours reset the thermostat to the desired position.
