montpellier MD09FS45W, Installation And Operating Instructions Manual

Page: 6 / 21

6
Section 1. Installation

Position the appliance in a dry, well ventilated room with a solid level floor.
The room temperature must not fall below +5°
or rise above +35°.
 This appliance is fitted with adjustable feet so that you can ensure it is sitting
level. Adjust the feet by turning left or right until the appliance is level.
 The adjustable feet must never be removed.

Plug the 3pin moulded plug into a nearby 13amp plug socket. Always make
sure that you can easily gain access to switch the power on or off at the plug
socket.

N.B. This appliance must be earthed!
 If you have installed this appliance underneath a work surface the plug
socket should have a fused switch located above the work surface so that
you can easily switch the appliance on or off.
 You are advised to turn the power off at the plug socket when you have
finished using your appliance.
 Before using the appliance for the first time, you must set the water softener,
add salt, add rinse aid and add detergent.
 To open the door, use the door handle and the catch will release. To close
the door, use the door handle to push the door and the catch will lock the
door. Never try to force open the door by any other method!
 Your plumber will connect the water hose (supplied) to the water inlet
connection at the rear of the appliance and to an adjacent cold water supply.
It is your responsibility to ensure that the supplied washers have been used
and that both connections are water tight.

Ensure water pressure is within the range specified on the Rating Label.
 Your plumber will connect the water drain pipe to an adjacent sink (see Pic.1
below)
 Ensure that the water hose and water drain pipe are not kinked when the
appliance is pushed into place. If either of these pipes is kinked the appliance
will not operate correctly.

Ensure that the appliance is not standing on the power cable.
Pic.1
.
Maximum
1000mm
Water Drain Pipe