4
S
ection 1. Installation
-
Remove all packaging, protective film and securing tape from
the appliance.
-
Position the appliance in a dry atmosphere.
-
The following dimensions are provided as a guide for
installation – your
GasSafe
installer will carry out the installation
in accordance with the current regulations.
-
Your
GasSafe
installer will connect the appliance in accordance
with the current regulations.
To install this appliance, please proceed as follows:
1.1. Work-Surface Cut-Out & Positioning
-
Cut out the work-top, ensuring that the actual sizes used are as
per the diagram below (815mm x 490mm).
-
For installation and use, a minimum of 5cm must be maintained
around the cut-out.
-
The work surface must have a thickness of at least 30mm.
-
The work surface must be heat resistant.
-
The rear edge of the hob must be at least 60mm from the rear
wall.
-
You must maintain a clearance of at least 700mm between the
top of the hob and any surface directly above it.
-
Note the clearances required between the hob/work surface
and any adjacent wall cupboard (400mm).
-
You must ensure that there is a minimum gap of 25mm
between the bottom surface of the hob and anything
positioned directly below it.
