XG0679 - 080321
3
General
Wiring Instructions
A qualified electrician should install the remote control system.
1. Disconnect and remove the wall switch wire from terminals 3 and
4 of the control box.
This remote control system must be installed exactly as outlined in
these instructions. Read all instructions completely before attempting
installation. Follow instructions carefully during installation. Any
modifications of this remote control or any of its components will void
the warranty and may pose a fire hazard.
WARNING
2. Feed the red wires from the remote receiver through the control
box side.
3. Connect the Red wires to Terminals 3 and 4 of the control box.
When connecting two connectors together on a single pole, place
connectors back-to-back.
3 4
3 4
110VAC
connection
Red wires
from receiver
4. Plug the power cord from the receiver into the 110VA plug on the
side of the control box.
5. Attach the receiver to the control box cover or to the wall using the
velcro strips attached.
Summary of Contents for RXM40VAC
Page 5: ...5 Notes XG0783 021121 ...
