Page 17
P/N XG0205
M40DV-PFC Peninsula Gas Fireplace
For Your Safety - READ BEFORE LIGHTING:
To Turn Off Gas To Appliance:
Lighting Instructions:
WARNING:
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
If you cannot reach your gas supplier, call the
Fire Department.
C.
Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, don't try to repair it,
call a qualified service technician. Force or at
-
tempt to repair may result in a fire or explosion.
D.
Do not use this appliance if any part has been
under water. Immediately call a qualified serv
-
ice technician to inspect the appliance and to
replace any part of the control system, and any
gas control which has been under water.
A.
This appliance is equipped with an ignition sys-
tem that lights the pilot burner automatically.
Do
not attempt to light the pilot by hand.
B. BEFORE LIGHTING
smell all around the appli-
ance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and
will settle on the floor.
What To Do If You Smell Gas:
Do not try to light any appliance.
Do not touch any electrical switch; do not use
any phone in your building.
Immediately call your gas supplier from a
neighbour's phone. Follow the gas supplier's
instructions.
1.
Turn off remote switch.
2.
Flip down the lower end louvres.
Gas
Inlet
Gas Control Switch
Shown in "On" Position
3.
Turn the switch on the gas control to "Off".
4.
Flip up the lower end louvres.
1.
STOP!
Read the safety information above on
this label.
2.
Flip down the lower louvres on the end panel of
the fireplace.
3.
Turn switch on the gas control to OFF".
4.
Wait 5 minutes to clear out any gas. If you smell
gas,
STOP!
Follow "B" in the safety information
above on this label. If you don't smell gas, go to
the next step.
5.
Turn switch on the gas control to "ON".
NOTE:
This unit is equipped with an ignition system that
lights the pilot burner automatically.
Do not at-
tempt to light the pilot by hand.
6.
Turn on wall switch.
7.
Flip up the lower end louvres..
8.
If the fireplace does not operate, follow the in
-
structions "To Turn Off Gas To Appliance" and
call your service technician or gas supplier.
Operation - Model M40DV-PFC-I
with Honeywell Intermittent Pilot
M40DV-PFC-I
