Page 21
L38DF* Indoor Gas Fireplace
XG0180 - 053111
Operation
Section 9: Start-up Sequence
Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the Fire Department.
C.
Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand, don't try
to repair it, call a qualified service technician. Force or attempt to repair
may result in a fire or explosion.
D.
Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the appliance
and to replace any part of the control system, and any gas control which
has been under water.
A.
This appliance has a pilot which must be lighted by hand. When
lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING
smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is heavier
than air and will settle on the floor.
What To Do If You Smell Gas:
Do not try to light any appliance.
Do not touch any electrical switch; do not use any phone in
your building.
Immediately call your gas supplier from a neighbour's phone.
To Turn Off Gas To Appliance:
3.
Push in gas control knob slightly and turn
clockwise to "Off".
Do not force.
4.
Replace the lower Horizontal access panel.
1
. Turn off remote switch.
2.
Lift out the lower Horizontal access panel
.
with Continuous Pilot
with American Flame Electronic Ignition
For Your Safety - READ BEFORE LIGHTING:
Lighting Instructions:
1.
STOP!
Read the safety information above on this label.
2.
Lift out the lower Horizontal access panel
.
3.
Push in gas control knob and turn clockwise
to "OFF."
4.
Wait five (5) minutes to clear out any gas. Smell for gas, including
near the floor. If you then smell gas,
STOP!
Follow "B" in the safety
information above on this label. If you don't smell gas, go to the
next step.
5.
Locate pilot burner
(See illustration at right.)
and follow steps below.
6.
Turn knob on gas control counter clockwise
to "PILOT."
7.
Push in gas control knob completely and hold. Light with Piezo
Igniter button. Continue to hold the control knob in for about (1)
minute after the pilot is lit. Release the knob and it will pop back
up. Pilot should remain lit. If it goes out repeat steps 3 through 8.
If knob does not pop up when released. Stop and immediately
call your service technician or gas supplier.
If the pilot will not stay lit after several tries, turn the gas control
knob to "OFF" and call your service technician or gas supplier.
8.
Push in gas control knob and turn counter-clockwise
to
"ON."
9.
Replace the lower Horizontal access panel.
10.
Turn on remote switch to ignite fire.
NOTE:
Gas control knob cannot be turned from "PILOT" to "OFF"
unless knob is pushed in slightly. Do not force.
Models
L38DFN
L38DFL
If the information in these instructions is not followed exactly, a fire or explosion may
result causing property damage, personal injury or death.
WARNING
