Montigo HFK50R, Installing

Page: 2 / 4

Installation Installation
Page 2
XT0015 - 150324
3. Install the right fan as shown in Figure 5 to the bracket underneath
the firebox using the screws supplied (motor should be oriented
towards the back side of the fireplace).
4. Plug in the 4-pin green connector from fan harness to X10 of the
control box.
5. Plug the 2-pin molex connectors on the other end of the harness
to the connectors from both fans. Note: the left or right fan can be
plugged into either plug.
2. Install the left fan as shown in Figure 4 to the bracket underneath
the firebox using the screws supplied (motor should be oriented
towards the back side of the fireplace).
Installation
1. Remove burner tray if required.
Burner Tray Gasket
17
18
Burner Tray Gasket
Figure 2
Removing the burner tray (L38DF, L42DF, L52DF
models only).
Figure 3
Removing the burner tray (L38DF, L42DF, L52DF
models only).
Figure 4
Install left fan to bracket
Figure 5
Install right fan to bracket
Figure 6
Some fans might come with the black & white wires in reverse
position. These are AC fans and are not affected by the polarity.
NOTICE