XG0302C
Page
EP8-5 Modular Series Fireplace
Installation
Installing Decorative
Burner Trays
The burner tray may be installed/upgraded before or after the EP28
outer shell has been installed.
1.
Remove the lower trims.
2.
If you are converting or upgrading an EP28 Series fireplace which
has doors installed, you must first remove the doors. To remove
the doors, push up firmly on the spring clip to release the top of
the door.Tilt the top of the door towards the middle of the fire
-
place, and lift the bottom door pin out of its locating hole.
Continue on with steps 3 - 9.
3.
Remove the four screws holding the front bar in place. See figure
6a.
4.
Warning:
You must disconnect the gas supply line from the
fireplace.
5.
If replacing an existing burner tray, remove the two screws located
at bottom rear of burner pan. Lift complete burner assembly, up
and out of unit to clear support ledge.
6.
Install the new burner by reversing step 5. Be sure to re-install
the two screws at the bottom rear of burner pan to secure pan into
place.
7.
Re-install the front bar. Make sure the front bar is secured with
four screws.
Notes:
A Spill Switch is suppled with each unit. This must be wired
in the Wall Switch - Gas Valve circuit. (See Figure 24a, 24b,
or 24c for Schematic Diagram.)
After gas line is connected
each appliance connection,
valve and valve train
must be checked while under normal
operating pressure with either a liquid solution, or leak detec-
tion device, to locate any source of leak. Tighten any areas
where bubbling appears or leak is detected until bubbling
stops completely or leak is no longer detected.
Do Not
use a
flame of any kind to test for leaks.
Figure 6.
Removing the front bar.
Figure 7.
Burner tray installation.
