Page 7
C38-BV Gas Fireplace
Part No. XG0314
Installation
NOTES
:
n
If logs are not placed properly, excessive sooting will result.
n
The surface of the logs will crack due to the heat from the
flames. This is a normal occurance.
Embers
Flame Shaper
Log 'A'
Figure 11.
Installing the horizontal trim pieces.
Installing the Trim & Baffle
The fireplace is shipped with 6 horizontal trim pieces (3 upper and 3
lower), which must be field-installed.
Install the trim by placing the top edge of the trim over to the
retainer clips on either side of the fireplace. Push the bottom edge
firmly inwards and the trim will snap on.
(See figure 11)
Remember to
slide the baffle into the top trim piece
.
(See Inset)
Note: Baffle should rest on top of the tabs.
Inset.
Slide in baffle
before installing top trim.
Installing the Log Set
Installing the Logs:
The
C38-BV
is supplied with five ceramic fibre logs. Unpack the logs
and handle them very carefully.
1.
Remove the door cover and the glass door.
2.
Place the Back log onto the back log rest as shown below in figure
10a. The log has lip on the bottom which fits into the slot on the log rest.
3.
Place the Front log onto the front log rest as shown in figure 10a.
Center the log from side to side, and push it against the back of
the log rest. Carefully push the log onto the metal spikes on the log rest.
4.
Place the top logs in position as shown in figure 10b, place the
centre log down first, then the right and left logs.
5.
Start the fireplace. If the flame appears satisfactory, replace the
glass door and door cover.
Figure 10a.
Positioning for the front and back logs.
Figure 10b.
Proper log placement.
