Montgomery Ward Chef TESTED 789019, Instruction Manual, Page: 4 / 8

1
•
888
•
557
•
3848 wards.com
7 6
How to Use How to Use
NOTE:
Before the first use, fill the coffee maker reservoir to the 12-cup level
and run the brew cycle (see below) with the water only (no coffee).
When brewing is done, dispose of the water and repeat.
SETTING THE CLOCK
1. Plug the power cord into an electrical outlet, the display will flash 12:00.
2. Turn the dial to HOUR and press the dial to set the hour. This is a 12-hour clock,
so the time will show AM or PM.
3. Turn the knob to MIN and press the dial to set the minutes..
USING YOUR COFFEE MAKER
1. Open the lid and fill the water reservoir with water. DO NOT exceed the 12-cup
mark on the water gauge.
2. Place the filter into the basket (if not assembled correctly, the lid will not close).
3. Put coffee grounds into the filter (refer to the coffee label for recommended
amount) and snap the lid shut.
4. Place the carafe with lid closed onto the heating plate.
5. Plug the power cord into an electrical outlet, the display will blink “12:00.” Use
the directions above to set the current time on the clock.
6. Set the dial to ON/OFF and press the knob once. The ON/OFF indicator will
shine red and the coffee maker will begin brewing.
7. If you want to brew stronger coffee, turn the dial to STRENGTH and press one
time. The indicator will shine orange. The coffee maker will begin to brew.
8. Cancel brewing at any time by turning the dial to ON/OFF and press one time.
The ON/OFF indicator will extinguish and the coffee maker will shut off.
NOTE:
While coffee is brewing, the carafe can be removed to pour a cup of
coffee. The coffee maker will stop dripping automatically for 30
seconds.
Pour with caution, as the coffee is very hot!
9. When coffee is finished brewing, remove the carafe to serve hot coffee.
Pour
with caution, as the coffee is very hot!
10. The heating plate will stay hot for 2 hours, and then shut off automatically.
11. Turn off and unplug the coffee maker when not in use.
SETTING DELAY BREW
1. Set the clock on the coffee maker per instructions on page 6.
2. Turn the dial to PROG and press once. The ON/OFF indicator will blink green,
and the display will flash 12:00.
3. To set the desired start time, turn the dial to HOUR and press the dial to set the
hour (this is a 12-hour clock, so the time will show AM or PM). Turn the knob to
MIN and press the dial to set the minutes..
4. After setting the desired start time, turn the dial to PROG and press once. The
ON/OFF indicator will shine green. The display will show the current time.
5. When the preset time is the same as current time, the ON/OFF indicator will
shine red and the coffee maker will start brewing.
6. When coffee is finished brewing, remove the carafe to serve hot coffee. Pour
with caution, as the coffee is very hot!
7. The heating plate will stay hot for 2 hours, and then shut off automatically.
8. Turn off and unplug the coffee maker when not in use.