5
© 2014 Monte Carlo Fan Company
11/1/2014
13
14
15
16
17
18
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
Loosen 2 and remove 1 preassembled
screw from light pan. Save screw for later
use.
Connect white wire from fan to white wire
from LED light kit and then connect blue
wire from fan to black wire from LED
light kit.
Attach LED light kit onto the light pan,
aligning the keyhole slots on the LED light
kit with the preassembled screws on the
light pan. Twist clockwise till lock.
Reinstall the screw removed in step 15.
Tighten all screws securely.
Attach Acrylic shade by locating dimples
in light pan with grooves on the Acrylic
shade and twist clockwise until tight.
Remove battery cover. Install 12V battery
into wall remote. Duracell MN21 /
Evereday A23 / GP 23A all 12V. Attach
cover of remote by placing over buttons
and snap the battery cover in place.
Attach light pan onto the plate on motor,
aligning the keyhole slots on the light
plate with the preassembled screws on
the plate. Twist clockwise till lock.
Reinstall the screw removed in step 13.
Tighten all screws securely.
Note
: Make sure the side with a label
“This side up” is installed upward.
Battery cover
Battery
Plate on motor
Light pan
Acrylic shade
LED light kit
Blue
Black
White
White
Summary of Contents for Diamond 4DDR52 D Series
Page 9: ...Nov 2014 ...
