Securely attached the mounting plate
to the outlet box using two screws
supplied by the outlet box. Use metal
outlet box suitable for fan support
(must support 35 lbs).
7
Lift motor housing up and turn motor
housing clockwise to hold in position.
11
Attach blade to blade bracket using
the 3 screws and washers provided.
Tighten each of the screws securely.
Repeat this process 4 more times.
12
Attach blade assembly to the motor
and tighen the 2 screws pre-installed
to the blade bracket. Repeat 4 more
times.
13
Loosen 2 screws, remove 1 screw
and lock washer from the motor
plate and save.
14
Attach the switch cap plate to the
motor plate. Align keyslot holes and
twist to lock. Tighten the screw and
lockwasher removed in step 14 and
tighten the other 2 screws and lock
washers securely.
15
Remove the double sided sticky tape
and stick the capacitor to the switch
cap plate.
16
Lift the motor bracket so that the
threaded studs on the mounting
plate protrude through the slots in
the motor bracket. Securely tighten
the locknuts onto the threaded
studs.
10
Make wire connections to the power source using wire
nuts provided. Make sure that no filiments are outside
of the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on
the other side of the outlet box. Spliced wires should
be turned upward and pushed carefully up into the
outlet box.
9
Connect black and blue wire from fan
to Black or (Hot) wire from house.
Connect White wire from Fan to
White (Neutral) wire from house.
Connect green wire from the fan to
the ground wire from the house.
Refer to Diagram above.
8
House
Fan
Blue
Black
White
Green
Black
White
Ground
Remove the 3 screws from the switch cap with
the fitter. Save for later use. To avoid possible
shock, the connectors should not be removed
unless a light kit will be immediately installed
and the power should be turned off prior to the
connector removal of the light kit.
17
For fan with light kit
go to step 18.
For fan without light
kit go to step 23 to
finish.
